|
|
|
|
|
|
|
|
|
|
|
|
Back |
|
Back to home |
|
|
| Acquisition system | |
| Number of input channels | 2 analog, BNC |
| Resolution | 8 bit @ 100 MHz 12 bit @ 50 MHz 14 bit @ 3.125 MHz 16 bit @ 195 kHz |
| Accuracy | 0.2% ± 1 LSB |
| Sensitivity | 200 mVolt .. 80 Volt full scale |
| Coupling | AC/DC |
| Impedance | 1 MOhm / 30 pF |
| Protection | 200 Volt (DC + AC peak < 10 kHz) |
| Bandwidth (-3dB) | DC to 50 MHz maximum |
| AC coupling cut off frequency (-3dB) | 1.5 Hz |
| Maximum sampling rate | 100 MHz, 10 nsec (model
HS3-100) 50 MHz, 20 nsec (model HS3-50 ) 25 MHz, 40 nsec (model HS3-25 ) 10 MHz, 100 nsec (model HS3-10 ) 5 MHz, 200 nsec (model HS3-5 ) |
| Sampling source | internal ±0.01%, external |
| Memory | 131072 samples each channel |
| Arbitrary Waveform Generator (independent from acquisition system) | |
| Number of output channels | 1 analog, BNC |
| Resolution | 14 bit @ 50 MHz |
| Amplitude | -12 Volt .. 12 Volt |
| Amplitude step | 0 - ±0.1 V range, 8192 steps ±0.1 - ±0.9 V range, 8192 steps ±0.9 - ±12 V range, 8192 steps |
| Coupling | DC |
| Impedance | 50 Ohm |
| Bandwidth | DC to 2MHz |
| DC level | 0 - ±12 V in 8192 steps |
| Sampling rate | 50 MHz |
| Sampling source | internal, 0.01% |
| Memory | 1024 points DDS mode 128K points linear mode |
| Waveforms | sine, triangle, square, DC, noise and user defined |
| Symmetry | 1 - 99%, 1% steps |
| Trigger system | |
| System | digital, 2 levels |
| Source | CH1, CH2, AND, OR, digital external |
| Trigger modes | rising slope, falling slope, inside window, outside window, peak |
| Level adjustment | 0 - 100% of full scale |
| Hysteresis adjustment | 0 - 100% of full scale |
| Resolution | 0.025% (12 bits) |
| Digital trigger input level | 0 - 3.3 volt (5 volt max) |
| Pre trigger | 0 - 131071 samples (0 - 100%, one sample resolution) |
| Post trigger | 0 - 131071 samples (0 - 100%, one sample resolution) |
| Interface | |
| Interface | USB 2.0 (USB 1 also supported) |
| Power Requirements | |
| Power from USB port | 500 mA max (2.5 Watt max) |
| Power via extension connector | 1500 mA max (7.5 Watt max) |
| Physical | |
| Instrument height | 25 mm (1 inch) |
| Instrument length | 170 mm (6.7 inch) |
| Instrument width | 140 mm (5.2 inch) |
| Cord length | 1.8 meter (70 inch) |
| Weight | 480 gram (17 ounce) |
| Accessories | 2 oscilloscope probes 1:1 - 1:10
switchable external power cable for PS/2 mouse or keyboard connector |
| Options | |
| Optionally available | 10 MHz generator output |
| Optionally available | Single channel Handyscope HS3 without generator, but with 512K samples memory |